Official Raz Veinz Blogsite

DIY : Honda Civic 1987-2000 Crack Steering Boot/Dust Seal Replacement

Posted on Monday, October 28th, 2013 at 11:58 am

 I replace this dust seal before, using the OEM Honda, but, I think it is not durable as original, I mean the old one, this is a little ‘bit disappointed’…

Check for the leaking, if your power steering reservoir runs low, no matter how frequently you top up the fluid, you should check entire power steering system, there must be leakage somewhere. Check the steering gearbox (steering rack system), pump, reservoir, pump outlet line (high pressure), low pressure hoses and pipe. Click here if you want to rebuild the entire steering rack.

Remove the cotton pin.

I highly recommend you to using ball joint remover instead of using hammer or etc.

Marking the alignment point with the tape to make sure the wheel alignment didn’t goes so far, I also note the threads, remove the boot band and the tube clamp.

Remove the tie-rod end, it’s tough and stubborn sometime…

Remove the crack dust seal. It’s a good time to re-grease  rack end ball joint and steering rack gear, my old grease is melting, should put the high temp grease…

Insert the new dust seal, reassembly all back together using reverse step.

This is the boring maintenance that I ever do….

You can leave a response, or trackback from your own site.

Leave a Reply

*